LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> G25 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Brake Control System) >> Ecu Diagnosis Information >> Abs Actuator And Electric Unit (Control Unit) >> Reference Value >> Consult Data Monitor Standard Value
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Consult Data Monitor Standard Value

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT DATA MONITOR STANDARD VALUE

Monitor item Condition Reference values in normal operation
FR LH SENSOR Vehicle stopped 0.00 km/h (MPH)
When driving straight ahead(1) Nearly matches the speedometer display (within ±10%)
FR RH SENSOR Vehicle stopped 0.00 km/h (MPH)
When driving straight ahead(1) Nearly matches the speedometer display (within ±10%)
RR LH SENSOR Vehicle stopped 0.00 km/h (MPH)
When driving straight ahead(1) Nearly matches the speedometer display (within ±10%)
RR RH SENSOR Vehicle stopped 0.00 km/h (MPH)
When driving straight ahead(1) Nearly matches the speedometer display (within ±10%)
ACCEL POS SIG Never depress accelerator pedal (with power switch ON) 0%
Depress accelerator pedal (with power switch ON) 0 - 100%
SIDE G-SENSOR Vehicle stopped Approx. 0 m/s2
Turning right Negative value
Turning left Positive value
BATTERY VOLT Power switch ON 10 - 16 V
DECEL G-SEN When stopped -0.11 - 0.11 G
During acceleration Negative value
During deceleration Positive value
STR ANGLE SIG When driving straight 0±2.5°
When steering wheel is steered to LH by 90° Approx. +90°
When steering wheel is steered to RH by 90° Approx. -90°
PRESS SENSOR Brake pedal not depressed Approx. 0 bar
Brake pedal depressed 0 - 255 bar
YAW RATE SEN Vehicle stopped Approx. 0 d/s
Turning right Negative value
Turning left Positive value
FR RH IN SOL(2) Active On
Not activated Off
FR RH OUT SOL(2) Active On
Not activated Off
FR LH IN SOL(2) Active On
Not activated Off
FR LH OUT SOL(2) Active On
Not activated Off
RR RH IN SOL(2) Active On
Not activated Off
RR RH OUT SOL(2) Active On
Not activated Off
RR LH IN SOL(2) Active On
Not activated Off
RR LH OUT SOL(2) Active On
Not activated Off
EBD WARN LAMP When brake warning lamp is ON(3) On
When brake warning lamp is OFF(3) Off
STOP LAMP SW Brake pedal depressed On
Brake pedal not depressed Off
ABS WARN LAMP When ABS warning lamp is ON(3) On
When brake warning lamp is OFF(3) Off
MOTOR RELAY Active On
Not activated Off
ACTUATOR RLY Active On
Not activated (in fail-safe mode) Off
OFF LAMP When VDC OFF indicator lamp is ON(3) On
When VDC OFF indicator lamp is OFF(3) Off
OFF SW VDC OFF switch ON On
VDC OFF switch OFF Off
SLIP/VDC LAMP When VDC warning lamp is ON(3) On
When VDC warning lamp is OFF(3) Off
EBD SIGNAL EBD is activated On
EBD is not activated Off
ABS SIGNAL ABS is activated On
ABS is not activated Off
TCS SIGNAL TCS is activated On
TCS is not activated Off
VDC SIGNAL VDC is activated On
VDC is not activated Off
EBD FAIL SIG In EBD fail-safe On
EBD is normal Off
ABS FAIL SIG In ABS fail-safe On
ABS is normal Off
TCS FAIL SIG In TCS fail-safe On
TCS is normal Off
VDC FAIL SIG In VDC fail-safe On
VDC is normal Off
GEAR Driving D, R, N/P
N POSI SIG When selector lever is in the N position On
When selector lever is in the other position than N Off
P POSI SIG When selector lever is in the P position On
When selector lever is in the other position than P Off
R POSI SIG When selector lever is in the R position On
When selector lever is in the other position than R Off
FLUID LEV SW When brake fluid level switch is ON (brake fluid level is less than the specified level) On
When brake fluid level switch is OFF Off
CV1(2) Active On
Not activated Off
CV2(2) Active On
Not activated Off
SV1(2) Active On
Not activated Off
SV2(2) Active On
Not activated Off
STOP LAMP SW2 Brake pedal depressed On
Brake pedal not depressed Off
(1) Confirm tire pressure is standard value.
(2) Refer to "valve operation" in "SYSTEM DESCRIPTION " for valve operation of each valve.
(3) Refer to "SYSTEM DESCRIPTION " for ON/OFF conditions of each warning lamp and indicator lamp.