Component Inspection (Accelerator Pedal Position Sensor)

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ACCELERATOR PEDAL POSITION (APP) SENSOR

Turn power switch OFF.
Reconnect all harness connectors disconnected.
Turn power switch ON.
Check the voltage VCM harness connector terminals under the following conditions.

VOLTAGE REFERENCE CHART

VCM			Condition		Voltage (V)
Connector	+	-
Connector	Terminal	Terminal
E62	38 (APP sensor 1)	141	Accelerator pedal	Fully released	0.45 - 1.0
	38 (APP sensor 1)			Fully depressed	4.4 - 4.8
	46 (APP sensor 2)			Fully released	0.22 - 0.5
	46 (APP sensor 2)			Fully depressed	2.1 - 2.5

Is the inspection result normal?

YES: INSPECTION END

NO: Replace accelerator pedal. Refer to "REMOVAL AND INSTALLATION ".