LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> G25 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Security Control System) >> System Description >> Diagnosis System (BCM) >> Intelligent Key >> INTELLIGENT KEY : CONSULT-III Function (BCM - INTELLIGENT KEY) >> Data Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data Monitor

WARNING: This page is about a different car, the 2011 Nissan 370Z. However, it is still accessible from the selected car via links, so may be relevant.
MONITOR ITEM DESCRIPTION

Monitor Item Condition
REQ SW-DR Indicates [On/Off] condition of driver side door request switch
REQ SW-AS Indicates [On/Off] condition of passenger side door request switch
REQ SW-BD/TR Indicates [On/Off] condition of back door request switch/trunk lid door request switch(4)
PUSH SW Indicates [On/Off] condition of push-button ignition switch
IGN RLY2 -F/B Indicates [On/Off] condition of ignition relay 2
ACC RLY-F/B
NOTE: This item is displayed, but cannot be monitored
CLUCH SW(1) Indicates [On/Off] condition of clutch switch
BRAKE SW 1 Indicates [On/Off](3) condition of brake switch power supply
BRAKE SW 2 Indicates [On/Off] condition of brake switch
DETE/CANCL SW(2) Indicates [On/Off] condition of P position
SFT PN/N SW(2) Indicates [On/Off] condition of P or N position
S/L-LOCK Indicates [On/Off] condition of steering lock unit (LOCK)
NOTE: For models without steering lock unit, this item is not monitored.
S/L-UNLOCK Indicates [On/Off] condition of steering lock unit (UNLOCK)
NOTE: For models without steering lock unit, this item is not monitored.
S/L RELAY-F/B Indicates [On/Off] condition of steering lock relay
NOTE: For models without steering lock unit, this item is not monitored.
UNLK SEN-DR Indicates [On/Off] condition of driver door UNLOCK status
PUSH SW-IPDM Indicates [On/Off] condition of push-button ignition switch
IGN RLY1 -F/B Indicates [On/Off] condition of ignition relay 1
DETE SW-IPDM(2) Indicates [On/Off] condition of P position
SFT PN-IPDM(2) Indicates [On/Off] condition of P or N position
SFT P-MET(2) Indicates [On/Off] condition of P position
SFT N-MET(2) Indicates [On/Off] condition of N position
ENGINE STATE Indicates [STOP/STALL/CRANK/RUN] condition of engine states
S/L LOCK-IPDM Indicates [On/Off] condition of steering lock unit (LOCK)
NOTE: For models without steering lock unit, this item is not monitored.
S/L UNLK-IPDM Indicates [On/Off] condition of steering lock unit (UNLOCK)
NOTE: For models without steering lock unit, this item is not monitored.
S/L RELAY-REQ Indicates [On/Off] condition of steering lock relay
NOTE: For models without steering lock unit, this item is not monitored.
VEH SPEED 1 Display the vehicle speed signal received from combination meter by numerical value [km/h]
VEH SPEED 2 Display the vehicle speed signal received from ABS or VDC or TCM by numerical value [km/h]
DOOR STAT-DR Indicates [LOCK/READY/UNLOCK] condition of driver side door status
DOOR STAT-AS Indicates [LOCK/READY/UNLOCK] condition of passenger side door status
ID OK FLAG Indicates [Set/Reset] condition of key ID
PRMT ENG STRT Indicates [Set/Reset] condition of engine start possibility
PRMT RKE STRT
NOTE: This item is displayed, but cannot be monitored
KEY SW-SLOT Indicates [On/Off] condition of key slot
TRNK/HAT MNTR
NOTE: This item is displayed, but cannot be monitored
RKE-LOCK Indicates [On/Off] condition of LOCK signal from Intelligent Key
RKE-UNLOCK Indicates [On/Off] condition of UNLOCK signal from Intelligent Key
RKE-TR/BD
NOTE: This item is displayed, but cannot be monitored
RKE-PANIC Indicates [On/Off] condition of PANIC button of Intelligent Key
RKE-P/W OPEN Indicates [On/Off] condition of P/W DOWN signal from Intelligent Key
RKE-MODE CHG Indicates [On/Off] condition of MODE CHANGE signal from Intelligent Key
RKE OPE COUN1 When remote keyless entry receiver (front) receives the signal transmitted while operating on Intelligent Key, the numerical value start changing
RKE OPE COUN2
NOTE: This item is displayed, but cannot be monitored
REVERSE SW(1) Indicates [On/Off] condition of R position
(1) It is displayed but does not operate on A/T models.
(2) It is displayed but does not operate on M/T models.
(3) OFF is displayed when brake pedal is depressed while brake switch power supply is OFF.
(4) For roadster models