LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> G25 x >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Brake System) >> DTC/Circuit Diagnosis >> DTC C1A6A: Control Module >> DTC Logic >> DTC Reproduction Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Reproduction Procedure

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING

    If another "DTC CONFIRMATION PROCEDURE" was performed just before, turn the power switch OFF and wait for at least and wait for 10 seconds or more, then perform the next test.

    Go to 2.

  2. CHECK DTC DETECTION

With CONSULT

  1. Turn the power switch OFF to ON.
    CAUTION: Never engage READY state.
  2. Repeat step  1 for 2 times or more.
    CAUTION: Be sure to wait for 5 seconds or more after turning the power switch OFF.
  3. Turn the power switch OFF.
  4. Close all doors including the back door, and wait outside of vehicle for 5 minutes or more.
  5. Turn the power switch ON.
    CAUTION: Never engage READY state.
  6. Erase self-diagnosis result of "BRAKE".
    CAUTION: Turn the power switch OFF and wait 5 minutes or more after erase self-diagnosis result.
  7. Depress brake pedal by 100 mm (3.94 in) or more, and hold the position for 5 seconds or more.
  8. Release brake pedal.
  9. Repeat steps  7 to  8 for 3 times.
  10. Perform "BRAKE" self-diagnosis.

Is DTC "C1A6A" detected? 

YES: Proceed to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END

scientia non olet · About LEMON Manuals