Precaution for Harness Repair

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.

Solder the repair part, and wrap it with tape. [Twisted wire fray must be 110 mm (4.33 in) or less.]

Fig 1: Identifying Soldered And Taped Area OK Position
Courtesy of NISSAN MOTOR CO., U.S.A.
Never bypass the repair point with wire. (If it is bypassed, the turnout point cannot be separated and the twisted wire characteristics are lost.)

Fig 2: Identifying Bypass Connection
Courtesy of NISSAN MOTOR CO., U.S.A.