Work Procedure

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.

SAVE VCM DATA
1. Turn off the power and wait at least 45 seconds.
2. Turn power switch ON.
3. Select "SAVE DATA FOR CPU REPLACE" in "WORK SUPPORT" mode using CONSULT.
4. Follow the instruction of CONSULT display.
NOTE: Necessary data in VCM is copied and saved to CONSULT.

Is operation completed successfully?

YES: Go to 2.

NO: Go to 4.
REPLACE VCM
1. Turn off the power and wait at least 45 seconds.
2. Replace VCM. Refer to "REMOVAL AND INSTALLATION ".
Go to 3.
WRITE VCM DATA
1. Select "WRITE DATA AFTER REPLACE CPU" in "WORK SUPPORT" mode using CONSULT.
2. Follow the instruction of CONSULT display.
NOTE: The data saved by "SAVE DATA FOR CPU REPLACE" is written to VCM.

Is operation completed successfully?

YES: Go to 8.

NO: Go to 5.
REPLACE VCM
1. Turn off the power and wait at least 45 seconds.
2. Replace VCM. Refer to "REMOVAL AND INSTALLATION ".
Go to 5.
LI-ION BATTERY ID REGISTRATION
Refer to the Li-ion Battery ID Registration Operation Instructions.

Go to 6.
PERFORM VCM KEY ID REGISTRATION
Refer to the CONSULT Operation instructions NATS-IVIS/NVIS.

Go to 7.
WRITE VIN DATA
Perform "WORK PROCEDURE ".

Go to 8.
PERFORM ACCELERATE PEDAL CLOSED POSITION LEARNING
Perform "WORK PROCEDURE ".

Go to 9.
SET VCM TIMER
Perform "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL: WORK PROCEDURE ".

Go to 10.
CHECK DTC
1. Turn off the power and wait at least 20 seconds.
2. Turn power switch ON.
3. Check DTC. If DTC is displayed, erase it.
END