Component Function Check

WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.

PRECONDITIONING
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is more than 12.8 V while power switch ON.
- Before performing the following procedure, confirm that all load switches and A/C switch are turned OFF.
Go to 2.

PERFORM COMPONENT FUNCTION CHECK

Turn power switch ON.
Check the voltage between VCM harness connector terminals.

VOLTAGE REFERENCE CHART

VCM			Voltage
Connector	+	-
Connector	Terminal
E62	42 (Battery current sensor signal)	43	Above 2.3 V at least once

Is the inspection result normal?

YES: INSPECTION END

NO: Proceed to "DIAGNOSIS PROCEDURE ".