DTC Confirmation Procedure
WARNING: This page is about a different car, the 2011 Nissan Leaf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Before performing the following procedure, confirm that 12V battery voltage is more than 11 V.
- PERFORM DTC CONFIRMATION PROCEDURE-I
- Turn power switch OFF and wait at least 60 seconds.
- Set the vehicle to READY and wait at least 200 seconds.
- Check DTC.
Is DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: Go to 2.
- PERFORM DTC CONFIRMATION PROCEDURE-II
- Turn power switch OFF and wait at least 60 seconds.
- Make sure that the charging status indicator does not illuminate.
- Connect normal charge connector (with AC power input) and wait at least 20 seconds.
- Check DTC.
Is DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: Go to 3.
- PERFORM DTC CONFIRMATION PROCEDURE-III
- Turn power switch OFF and wait at least 60 seconds.
- Make sure that the charging status indicator does not illuminate.
- Connect quick charge connector.
- Start quick charging and wait at least 20 seconds.
- Check DTC.
Is DTC detected?
YES: Proceed to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END