Power Supply Position Change Table By Push-Button Ignition Switch Operation
WARNING: This page is about a different car, the 2011 Infiniti G37. However, it is still accessible from the selected car via links, so may be relevant.
The power supply position changing operation can be performed with the following operations.
NOTE:
- When an Intelligent Key is within the detection area of inside key antenna and when it is inserted to the key slot, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions,
A/T models
- Brake pedal operating condition
- Selector lever position
- Vehicle speed
M/T models
- Clutch pedal operating condition
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
POWER SUPPLY POSITION CHANGE CHART
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| A/T models | M/T models | |||
| Selector lever position | Brake pedal operation condition | Clutch pedal operation condition | ||
| LOCK → ACC | - | Not depressed | Not depressed | 1 |
| LOCK → ACC → ON | - | Not depressed | Not depressed | 2 |
| LOCK → ACC → ON → OFF | - | Not depressed | Not depressed | 3 |
| LOCK → START ACC → START ON → START |
P or N position | Depressed | Depressed | 1 |
| Engine is running → OFF | - | - | - | 1 |
Vehicle speed: 4 km/h (2.5 MPH) or more
POWER SUPPLY POSITION CHANGE CHART
| Power supply position | Engine start/stop condition | Push-button ignition switch operation frequency | ||
|---|---|---|---|---|
| A/T models | M/T models | |||
| Selector lever position | Brake pedal operation condition | Clutch pedal operation condition | ||
| Engine is running → ACC | - | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | Depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.