Diagnosis Procedure

WARNING: This page is about a different car, the 2010 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
  - Harness connector E4
  - Harness connector M2
    Is the inspection result normal?
    
    YES: GO TO 2.
    
    NO: Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Disconnect the following harness connectors.
- ABS actuator and electric unit (control unit)
- Harness connectors E4 and M2

Check the continuity between the ABS actuator and electric unit (control unit) harness connector and the harness connector.

CONNECTOR TERMINAL CONTINUITY CHART

ABS actuator and electric unit (control unit) harness connector		Harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.	Continuity
E33	26	E4	9	Existed
E33	15	E4	25	Existed

Is the inspection result normal?

YES: GO TO 3.

NO: Repair the main line between the ABS actuator and electric unit (control unit) and the harness connector E4.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Check the continuity between the harness connector and the data link connector.

CONNECTOR TERMINAL CONTINUITY CHART

Harness connector		Data link connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.	Continuity
M2	9	M22	6	Existed
M2	25	M22	14	Existed

Is the inspection result normal?

YES (Present error): Check CAN system type decision again.

YES (Past error): Error was detected in the main line between the ABS actuator and electric unit (control unit) and the data link connector.

NO: Repair the main line between the harness connector M2 and the data link connector.