Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

INSPECTION START
1. Turn ignition switch ON.
2. Check "Self-diagnostic result" using CONSULT.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure.
  See "DTC LOGIC ".
  
  Is the DTC B260F displayed again?
  
  YES: GO TO 2.
  
  NO: GO TO 3.
REPLACE ECM
Replace ECM. Refer to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (ECM): DESCRIPTION ".

: INSPECTION END
CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".

: INSPECTION END