LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2012 >> G37 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 33 (Security Control System (Coupe)) >> System Description >> Diagnosis System (IPDM E/R) >> Diagnosis Description >> Auto Active Test >> Operation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Operation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Close the hood and lift the wiper arms from the windshield. (Prevent windshield damage due to wiper operation)
    NOTE: When auto active test is performed with hood opened, sprinkle water on windshield beforehand.
  2. Turn the ignition switch OFF.
  3. Turn the ignition switch ON, and within 20 seconds, press the front door switch (driver side) 10 times. Then turn the ignition switch OFF.
    CAUTION: Close passenger door.
  4. Turn the ignition switch ON within 10 seconds. After that the horn sounds once and the auto active test starts.
  5. The oil pressure warning lamp starts blinking when the auto active test starts.
  6. After a series of the following operations is repeated 3 times, auto active test is completed.
    NOTE: When auto active test mode has to be cancelled halfway through test, turn the ignition switch OFF.
    CAUTION:
    • If auto active test mode cannot be actuated, check door switch system. Refer to "COMPONENT FUNCTION CHECK ".
    • Do not start the engine.
scientia non olet · About LEMON Manuals