Check Anti-Pinch Function
WARNING: This page is about a different variant/trim than selected.
- Fully open the door window.
- Place a piece of wood near the fully closed position.
- Close door glass completely with AUTO-UP.
- Check that glass lowers for approximately 150 mm (5.9 in) without pinching piece of wood and stops.
- Check that glass does not rise when operating the power window switch while lowering.
CAUTION:
- Never check with hands and other part of body because they may be pinched. Never get pinched.
- Check that AUTO-UP operates before inspection when system initialization is performed.
- It may switch to fail-safe mode if open/close operation is performed continuously. Perform initial setting in that situation. Refer to "FAIL-SAFE "
- Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
- Finish initial setting. Otherwise, next operation cannot be performed.
- Auto-up operation
- Anti-pinch function
- Key cylinder switch power window function
- Automatic window adjusting function