WITH PLASMACLUSTER SYSTEM: Exhaust Gas/Outside Odor Detecting Sensor Sensitivity Adjustment Function: Description
WARNING: This page is about a different variant/trim than selected.
According to customer's sense of smell, exhaust gas/outside odor detecting sensor sensitivity can be changed.
Operating procedures for this trimmer are as follows:
- Begin self-diagnosis STEP-5 mode. Refer to "WITH PLASMACLUSTER SYSTEM: Diagnosis Description ".
- Press fan (UP: +) switch two times to set system in auxiliary mode.
- Turn temperature control dial (driver side) as desired.
| Display | Setting |
|---|---|
| 71 | Less sensitive setting than display 72 setting (the change to REC is later than display 72 operation) |
| 72 | Less sensitive setting than normal setting (the change to REC is later than normal operation) |
| 73 | Normal (Initial setting) |
| 74 | More sensitive setting than normal setting (the change to REC is earlier than normal operation) |
| 75 | More sensitive setting than display 74 setting (the change to REC is earlier than display 74 operation) |
NOTE:
When battery cable is disconnected or battery voltage is below 10 V, exhaust gas/outside odor detecting sensor sensitivity adjustment function is canceled. Exhaust gas/outside odor detecting sensor sensitivity adjustment function set becomes that of initial condition.