WITHOUT PLASMACLUSTER SYSTEM: Inlet Port Memory Function: Description
WARNING: This page is about a different variant/trim than selected.
When ignition switch is turned from OFF to ON, inlet port can be set to AUTO or manual.
Operating procedures for this trimmer are as per the following:
- Begin self-diagnosis STEP-5 mode. Refer to "WITHOUT PLASMACLUSTER SYSTEM: Diagnosis Description ".
- Press fan (UP: +) switch*1 (turn fan control dial clockwise*2) to set system in auxiliary mode.NOTE: *1: With left and right ventilation temperature separately system.
*2: Without left and right ventilation temperature separately system. - Press intake switch as desired.
| FRE indicator | REC indicator | Setting status | Setting changeover method | |
|---|---|---|---|---|
| FRE | REC | |||
| OFF | ON | AUTO control (Initial setting) | Manual REC status is memorized. (Initial setting) | Intake switch: ON |
| ON | ON | Manual FRE status is memorized. | Manual REC status is memorized. | |
| ON | OFF | Manual FRE status is memorized. | AUTO control | |
| OFF | OFF | AUTO control | AUTO control | |
NOTE:
When battery cable is disconnected or battery voltage is below 10 V, memory function is canceled. Memory function set becomes that of initial condition.