Data Monitor
WARNING: This page is about a different variant/trim than selected.
| Monitor Item | Condition | ||||
|---|---|---|---|---|---|
| REQ SW-DR | Indicates [ON/OFF] condition of door request switch (driver side). | ||||
| REQ SW-AS | Indicates [ON/OFF] condition of door request switch (passenger side). | ||||
| REQ SW-BD/TR | Indicates [ON/OFF] condition of trunk opener request switch. | ||||
| PUSH SW | Indicates [ON/OFF] condition of push-button ignition switch. | ||||
| IGN RLY2 -F/B | Indicates [ON/OFF] condition of ignition relay 2. | ||||
| ACC RLY-FB |
NOTE:
This item is displayed, but cannot be monitored.
|
||||
| CLUTCH SW(1) | Indicates [ON/OFF] condition of clutch switch. | ||||
| BRAKE SW 1 | Indicates [ON/OFF](2) condition of brake switch power supply. | ||||
| BRAKE SW 2 | Indicates [ON/OFF] condition of brake switch. | ||||
| DETE/CANCL SW | Indicates [ON/OFF] condition of P position. | ||||
| SFT PN/N SW | Indicates [ON/OFF] condition of P or N position. | ||||
| S/L-LOCK |
NOTE:
This item is displayed, but can not be monitored.
|
||||
| S/L-UNLOCK |
NOTE:
This item is displayed, but can not be monitored.
|
||||
| S/L RELAY-F/B |
NOTE:
This item is displayed, but can not be monitored.
|
||||
| UNLK SEN-DR | Indicates [ON/OFF] condition of driver door UNLOCK status. | ||||
| PUSH SW-IPDM | Indicates [ON/OFF] condition of push-button ignition switch. | ||||
| IGN RLY1 -F/B | Indicates [ON/OFF] condition of ignition relay 1. | ||||
| DETE SW-IPDM | Indicates [ON/OFF] condition of P position. | ||||
| SFT PN-IPDM | Indicates [ON/OFF] condition of P or N position. | ||||
| SFT P-MET | Indicates [ON/OFF] condition of P position. | ||||
| SFT N-MET | Indicates [ON/OFF] condition of N position. | ||||
| ENGINE STATE | Indicates [STOP/STALL/CRANK/RUN] condition of engine states. | ||||
| S/L LOCK-IPDM |
NOTE:
This item is displayed, but can not be monitored.
|
||||
| S/L UNLK-IPDM |
NOTE:
This item is displayed, but can not be monitored.
|
||||
| S/L RELAY-REQ |
NOTE:
This item is displayed, but can not be monitored.
|
||||
| VEH SPEED 1 | Display the vehicle speed signal received from combination meter by numerical value [Km/h]. | ||||
| VEH SPEED 2 | Display the vehicle speed signal received from ABS or VDC or TCM by numerical value [Km/h]. | ||||
| DOOR STAT-DR | Indicates [LOCK/READY/UNLOCK] condition of driver side door status. | ||||
| DOOR STAT-AS | Indicates [LOCK/READY/UNLOCK] condition of passenger side door status. | ||||
| ID OK FLAG | Indicates [SET/RESET] condition of key ID. | ||||
| PRMT ENG STRT | Indicates [SET/RESET] condition of engine start possibility. | ||||
| PRMT RKE STRT |
NOTE:
This item is displayed, but cannot be monitored.
|
||||
| KEY SW-SLOT | Indicates [ON/OFF] condition of key slot. | ||||
| TRNK/HAT MNTR | Indicates [ON/OFF] condition of trunk lid. | ||||
| RKE-LOCK | Indicates [ON/OFF] condition of LOCK signal from Intelligent Key. | ||||
| RKE-UNLOCK | Indicates [ON/OFF] condition of UNLOCK signal from Intelligent Key. | ||||
| RKE-TR/BD | Indicates [ON/OFF] condition of TRUNK OPEN signal from Intelligent Key. | ||||
| RKE-PANIC | Indicates [ON/OFF] condition of PANIC button of Intelligent Key. | ||||
| RKE-P/W OPEN | Indicates [ON/OFF] condition of P/W DOWN signal from Intelligent Key. | ||||
| RKE-MODE CHG | Indicates [ON/OFF] condition of MODE CHANGE signal from Intelligent Key. | ||||
| RKE OPE COUN1 | When remote keyless entry receiver receives the signal transmitted while operating on Intelligent Key, the numerical value start changing. | ||||
| RKE OPE COUN2 |
NOTE:
This item is displayed, but cannot be monitored.
|
||||
|
|||||