DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 11 V at idle. 

   : GO TO 2.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Set selector lever to P position.
3. Turn ignition switch ON.
4. Make sure that air conditioner switch and electric load switches (lights, heater fan, rear window defogger) are OFF.
5. Select "DATA MONITOR" mode of "ENGINE" with CONSULT.
6. Check the indication of "COOLAN TEMP/S".

   If it is between 4°C (39°F) and 36°C (97°F), go to the following steps.

   If it is below 4°C (39°F), warm engine up to more than 4°C (39°F) and retry from step  1.

   If it is above 36°C (97°F), cool engine down to less than 36°C (97°F) and retry from step  1.

7. Confirm that the "SOC" indication in "DATA MONITOR" mode of "EV/HEV" with CONSULT is between 35 and 70 %.
8. Perform "INSPECTION MODE 5". Refer to "DESCRIPTION ".
9. Start engine and let it idle for 35 seconds.
10. Check 1st trip DTC.

    Is 1st trip DTC detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END