Brake Actuator

NOTE: The test can be performed only when the engine is running.

Test item	Operation	Description	"PRESS SENS" value
BRAKE ACTUATOR	MODE1	Transmits the brake fluid pressure control signal to the ABS actuator and electric unit (control unit) via CAN communication	10 bar
	MODE2		20 bar
	MODE3		30 bar
	Test start	Starts the tests of "MODE1", "MODE2" and "MODE3"	-
	Reset	Stops transmitting the brake fluid pressure control signal below to end the test	-
	End	Returns to the "SELECT TEST ITEM" screen	-

NOTE: The test is finished in 10 seconds after starting

Fig 1: Identifying Brake Actuator Pressure Modes

Courtesy of NISSAN NORTH AMERICA, INC.

Active Pedal

CAUTION:

Shift the selector lever to "P" position, and then perform the test.
Never depress the accelerator pedal excessively. (The engine speed may rise unexpectedly when finishing the test.)

NOTE:

Test item	Operation	Description	Accelerator pedal operation
Active Pedal	MODE1	Transmit the accelerator pedal feedback force control signal to the accelerator pedal actuator via ITS communication.	Constant with a force of 25 N for 8 seconds
	MODE2		Constant with a force of 15 N for 8 seconds
	MODE3		Change up to a force of 25 N for 8 seconds
	MODE4		Change up to a force of 15 N for 8 seconds
	Test start	Starts the tests of "MODE1", "MODE2", "MODE3" and "MODE4"	-
	Reset	Stops transmitting the accelerator pedal feedback force control signal below to end the test.	-
	End	Returns to the "SELECT TEST ITEM" screen	-

NOTE: The test is finished in 10 seconds after starting

Fig 2: Identifying Active Pedal Pressure Modes

Courtesy of NISSAN NORTH AMERICA, INC.