| ADAS control unit |
- Being connected with side radar (LH and RH) via ITS communication, receives vehicle detection signal and transmits BSW/BSI indicator signal and BSW/BSI indicator dimmer signal to side radar
- Being connected with lane camera unit via ITS communication, receives detected lane condition signal
- Receives steering angle sensor signal from steering angle sensor via CAN communication
- Judges a BSW/BSI indicator ON/OFF state and an approach state to the lane marker, based on each signal and calculates yaw moment to help return the vehicle back to the center of the lane.
- Transmits target yaw moment signal to ABS actuator and electric unit (control unit)
- Activates the warning buzzer and warning systems ON indicator
- Transmits BSI ON indicator signal and BSW/BSI warning lamp signal to combination meter via CAN communication
|
| Side radar LH/RH |
- Being connected with ADAS control unit via ITS communication, transmits vehicle detection signal
- Receives BSW/BSI indicator signal and BSW/BSI indicator dimmer signal from ADAS control unit and transmits an indicator operation signal to BSW/BSI indicator LH/RH
- RH side radar equips right/left switching signal circuit for identifying LH or RH because the parts of side radar are common for right and left
|
| BSW/BSI indicator LH/RH |
Receives BSW/BSI indicator operation signal from side radar LH/RH and turns OFF, turns ON or blinks |
| Lane camera unit |
- Detects the lane marker by the built-in camera
- Transmits detected lane condition signal to ADAS control unit
|
| ABS actuator and electric unit (control unit) |
- Transmits vehicle speed signal to ADAS control unit via CAN communication
- Transmits yaw rate signal/side G sensor signal to ADAS control unit via CAN communication
- Receives a target yaw moment signal from the ADAS control unit via CAN communication and controls brake pressure of four wheels, respectively
|
| Warning systems switch |
Inputs the switch signal to ADAS control unit |
| Dynamic driver assistance switch |
Inputs the switch signal to ECM |
| Warning systems ON indicator (On the warning systems switch) |
Indicates BSW system status |
| Warning buzzer |
Receives buzzer signal from ADAS control unit and sounds buzzer. |
| Combination meter |
- Turns the BSW/BSI warning lamp and BSI ON indicator ON/OFF according to the signals from the ADAS control unit via CAN communication
- Receives BSI ON indicator signal, and BSW/BSI warning lamp signal via CAN communication.
|
| Steering angle sensor |
Transmits steering angle sensor signal to ADAS control unit via CAN communication |
| BCM |
- Transmits turn indicator signal to ADAS control unit via CAN communication
- Transmits dimmer signal to ADAS control unit via CAN communication
|
| ECM |
Transmits the accelerator pedal position signal, engine speed signal and ICC steering switch signal (dynamic driver assistance switch signal) to ADAS control unit via CAN communication |
| TCM |
Transmits the output shaft speed signal, input speed signal, current gear position signal and shift position signal to ADAS control unit via CAN communication |
| A/C auto amp. |
Transmits the mode selection state of the drive mode select switch to ADAS control unit via CAN communication |
| AV control unit |
Transmits the system selection signal to ADAS control unit via CAN communication |