Removal and Installation: Removal
CAUTION:
- Never erase the memory (history) of self-diagnosis results when replacing 4WAS main control unit after diagnosis.
- Erase the memory of the self-diagnosis results (record) after printing out or recording all the values of "DATA MONITOR".
- Turn the ignition switch OFF.
- Remove the trunk side finisher (LH). Refer to "TRUNK SIDE FINISHER: REMOVAL AND INSTALLATION ".
- Disconnect 4WAS main control unit connectors, 4WAS rear motor relay connector and noise suppressor connectors.
- Remove the 4WAS main control unit bolts.
- Remove the 4WAS main control unit.