DTC Confirmation Procedure
- INSPECTION START
Will CONSULT be used?
Will CONSULT be used?
YES: GO TO 2.
NO: GO TO 5.
- PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
: GO TO 3.
- CHECK PNP SIGNAL
WITH CONSULT
- Turn ignition switch ON.
- Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT. Then check the "P/N POSI SW" signal under the following conditions.
Position (Selector lever) Known-good signal N or P position ON Except above position OFF Is the inspection result normal?
YES: GO TO 4.
NO: Go to "DIAGNOSIS PROCEDURE ".
- PERFORM DTC CONFIRMATION PROCEDURE
- Select "DATA MONITOR" mode with CONSULT.
- Start engine and warm it up to normal operating temperature.
- Maintain the following conditions for at least 50 consecutive seconds.CAUTION: Always drive vehicle at a safe speed.
ENG SPEED 1, 300 - 6, 375 rpm COOLAN TEMP/S More than 70°C (158°F) B/FUEL SCHDL 2.0 - 31.8 msec VHCL SPEED SE More than 64 km/h (40 mph) Selector lever Suitable position - Check 1st trip DTC.
Is 1st trip DTC detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END
- PERFORM COMPONENT FUNCTION CHECK
WITH GST
Perform Component Function Check. Refer to "COMPONENT FUNCTION CHECK ".
NOTE: Use Component Function Check to check the overall function of the park/neutral position (PNP) signal circuit.
During this check, a 1st trip DTC might not be confirmed.Is the inspection result normal?
YES: INSPECTION END
NO: Go to "DIAGNOSIS PROCEDURE ".