DTC Confirmation Procedure

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is 11 V or more at idle. 

: GO TO 2.

1. Clear the mixture ratio self-learning value. Refer to "WORK PROCEDURE ".
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Turn ignition switch OFF and wait at least 10 seconds.
5. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for 1 minute under no load.
6. Let engine idle for 1 minute.
7. Keep engine speed between 2, 500 and 3, 000 rpm for 20 minutes.
8. Check 1st trip DTC.

Is 1st trip DTC detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END