DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

If engine will not start or stops soon, wait at least 10 seconds with engine stopped (Ignition switch ON) instead of running engine at idle speed.

: GO TO 2.

With CONSULT 

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
2. Start engine and warm it up to normal operating temperature.
3. Drive the vehicle under the following conditions.
   • Accelerate the vehicle from 0 to 88 km/h (0 to 55 MPH) under the following conditions:
     CAUTION: Always drive at a safe speed.
     NOTE:

     • Accelerate with the accelerator pedal kept constant.
     • The acceleration at engine speed 2, 000 and 3, 000 rpm allows easy diagnoses.

   ACCEL SEN 1	1.4 - 2.0 V
   Selector lever	D position

4. Check 1st trip DTC.

Without CONSULT 

1. Start engine and warm it up to normal operating temperature.
2. Drive the vehicle under the following conditions.
   • With selector lever in D position, accelerate the vehicle from 0 to 88 km/h (0 to 55 MPH) under the following conditions:
     CAUTION: Always drive at a safe speed.
     NOTE:

     • Accelerate with the accelerator pedal kept constant.
     • The acceleration at engine speed 2, 000 and 3, 000 rpm allows easy diagnoses.

   Accelerator pedal position sensor 1		Ground	Voltage (V)
   Connector	Terminal
   E110 (Without ICC)	3	Ground	1.4 - 2.0
   E67 (With ICC)	10

3. Check 1st trip DTC.

Is 1st trip DTC detected? 

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END