Active Test Mode
WARNING: This page is about a different car, the 2012 Infiniti M35h. However, it is still accessible from the selected car via links, so may be relevant.
TEST ITEM
| Test item | Condition | Judgement | Check item (Remedy) |
|---|---|---|---|
| INSPECTION MODE 1 | Prohibits engine idle stop under engine no-load conditions. Clutch 1: Disengaged Traction motor: Not operating |
|
Example: inspections that are performed with no load on the engine |
| INSPECTION MODE 2 | Changes the regenerative braking balance of the front and rear wheels when driving on a 2-wheel chassis dynamometer. |
|
Example: driving on a 2-axle chassis dynamometer |
| INSPECTION MODE 3 | Prohibits gradient estimation when driving on a 4-wheel chassis dynamometer. |
|
Example: driving on a 4-axle chassis dynamometer |
| INSPECTION MODE 5 | Prohibits engine idle stop in order to perform emissions measurement. |
|
Example: driving using the engine only |
| ENGINE CRANKING | This vehicle inspection mode stops fuel injection control and ignition timing control and performs cranking. | Runs the engine in vehicle READY state. | Inspection of engine compression pressure and other items |
| WATER PUMP | Forcibly drives the electric water pump to check pump operation and when adding coolant. | Electric water pump operates when ignition switch is ON. |
|
| VOLTAGE CONTROL | Changes the voltage command value periodically in order to check operation of the DC/DC converter. | Changes the DC/DC converter drive voltage between 13V and 15V (20 second cycle). |
|
|
Check the conditions listed below before using inspection mode 1.
CAUTION:
|
|||