Work Procedure

NOTE: In fail-safe mode, can not perform work support. (Except that DTC P181F is detected.)

WRITE UNIT PARAMETER
Perform writing unit parameter to control unit. Refer to "WORK PROCEDURE ".

: GO TO 2.
PREPARATION BEFORE WORK
With CONSULT
1. Start the engine.
  CAUTION: Never drive the vehicle.
2. Check "4WD MODE", "T/M RANGE", "COMPR VHCL SPEED", "MOTOR POWER SUP" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
3. Continue the following condition more than 10 seconds.
  4WD MODE: AUTO
  
  T/M RANGE: N
  
  COMPR VHCL SPEED: 0 km/h (Never drive the vehicle)
  
  MOTOR POWER SUP: More than 11 V
  
  : GO TO 3.
PERFORM TRANSFER FLUID VISCOSITY LEARNING
With CONSULT
1. Select "OIL DETERIORATION INFO RESET" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
2. Select "Start".
  : GO TO 4.
INITIAL CALIBRATION
With CONSULT
1. Select "START CALIBRATION" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
2. Wait until the motor operation stop. (After approximately 10 seconds)
  : GO TO 5.
PERFORM SELF-DIAGNOSIS
With CONSULT
1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
2. Turn the ignition switch ON to OFF.
  CAUTION: Wait for 10 seconds after turning ignition switch OFF.
3. Start the engine.
  CAUTION: Never drive the vehicle.
4. Perform self-diagnosis for "ALL MODE AWD/4WD".
  Is "DTC P181F" detected?
  
  YES: GO TO 1.
  
  NO: WORK END