LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2014 >> Q60 Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Audio, Visual & Navigation System (Base Audio Without Navigation) (Convertible) >> DTC/Circuit Diagnosis >> Camera Image Signal Circuit >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK CONTINUITY CAMERA POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect AV control unit connector and rear view camera connector.
    3. Check continuity between AV control unit harness connector and rear view camera harness connector.
      AV control unit Rear view camera Continuity
      Connector Terminal Connector Terminal
      M203 73 B311 1 Existed
    4. Check continuity between AV control unit harness connector and ground.
      AV control unit Ground Continuity
      Connector Terminal
      M203 73 Not existed

      Is inspection result normal? 

      YES: GO TO 2.

      NO: Repair harness or connector.

  2. CHECK VOLTAGE CAMERA POWER SUPPLY 
    1. Connect AV control unit connector and rear view camera connector.
    2. Turn ignition switch ON.
    3. Shift the selector lever to "R".
    4. Check voltage between AV control unit harness connector and ground.
      (+) (-) Condition Voltage (Approx.)
      AV control unit
      Connector Terminal
      M203 73 Ground Shift position is "R". 6.0 V

      Is inspection result normal? 

      YES: GO TO 3.

      NO: Replace AV control unit. Refer to "EXPLODED VIEW ".

  3. CHECK CONTINUITY CAMERA IMAGE SIGNAL CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect AV control unit connector and rear view camera connector.
    3. Check continuity between AV control unit harness connector and rear view camera harness connector.
      AV control unit Rear view camera Continuity
      Connector Terminal Connector Terminal
      M203 62 B311 3 Existed
    4. Check continuity between AV control unit harness connector and ground.
      AV control unit Ground Continuity
      Connector Terminal
      M203 62 Not existed

      Is inspection result normal? 

      YES: GO TO 4.

      NO: Repair harness or connector.

  4. CHECK CAMERA IMAGE SIGNAL 
    1. Connect AV control unit connector and rear view camera connector.
    2. Turn ignition switch ON.
    3. Shift the selector lever to "R".
    4. Check signal between AV control unit harness connector and ground.
      (+) (-) Condition Reference value
      AV control unit
      Connector Terminal
      M203 62 Ground At rear view camera image is displayed.
      G04890020

      Is inspection result normal? 

      YES: Replace AV control unit. Refer to "EXPLODED VIEW ".

      NO: Replace rear view camera. Refer to "EXPLODED VIEW ".

scientia non olet · About LEMON Manuals