Detailed Flow
- CHECK ENGINE START
Crank the engine and check that the engine starts.
Does the engine start?
YES: GO TO 2.
NO: GO TO 3.
- CHECK THAT THE STARTER MOTOR STOPS
Check that the starter motor stops after starting the engine.
Does the starter motor stop?
YES: INSPECTION END
NO: Replace starter motor. Refer to "REMOVAL AND INSTALLATION ".
- CHECK THAT THE ENGINE TURNS WHEN CRANKING
Check that the engine turns when cranking.
Does engine turn when cranking?
YES: GO TO 4.
NO: GO TO 5.
- CHECK THE ENGINE SPEED WHEN CRANKING
Check that the engine speed is not low when cranking.
Does engine turn normally?
YES: Check ignition/fuel system.
NO: Check charge condition, corrosion and connection condition of the battery. Refer to "WORK FLOW ".
- CHECK STARTER MOTOR ACTIVATION
Check that the starter motor runs at cranking.
Does starter motor turn?
YES: Replace starter motor. Refer to "REMOVAL AND INSTALLATION ".
NO: GO TO 6.
- CHECK POWER SUPPLY CIRCUIT
Check the following conditions.
- Fuse and fusible link
- Charge condition, corrosion and connection condition of the battery. Refer to
"WORK FLOW
".
Are these inspection results normal?
YES: GO TO 7.
NO: Repair as needed.
- CHECK STARTING SYSTEM WIRING
Check the following.
- "B" terminal circuit. Refer to "DIAGNOSIS PROCEDURE ".
- "S" connector circuit. Refer to
"DIAGNOSIS PROCEDURE ".
Are these inspection results normal?
YES: Replace starter motor. Refer to "REMOVAL AND INSTALLATION ".
NO: Repair as needed.