LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2014 >> Q60 Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis (Single Page) >> General Information >> Reset Procedures >> Maintenance Reminder Light (Reset Procedures) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 01 >> Tire Pressure Sensor ID Registration Without TPMS Sensor Activation Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Tire Pressure Sensor ID Registration Without TPMS Sensor Activation Tool

NOTE: The service data for some models does not include this procedure. This method of tire pressure sensor registration may or may not work with all models.
  1. With the ignition switch in OFF position, connect CONSULT (CONSULT-II with CONSULT-II CONVERTER on older models) to the Data Link Connector (DLC). Turn ignition switch to ON position.
  2. Select "START (NISSAN BASED VHCL)".
  3. Touch "BCM" on "SELECT SYSTEM" screen.
  4. Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
  5. Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
  6. Adjust the tire pressure to the specified values for ID registration. See ID REGISTRATION TIRE PRESSURE SPECIFICATIONS  table.
    ID REGISTRATION TIRE PRESSURE SPECIFICATIONS

    Tire Position Tire Pressure - psi (kPa)
    Front Left 34 (240)
    Front Right 31 (220)
    Rear Right 29 (200)
    Rear Left 26 (190)
  7. Drive the vehicle at 25 mph (40 km/h) or more for a few minutes.
  8. After completing all ID registrations, press "END" on CONSULT to complete the procedure.
  9. Inflate all tires to specification.
scientia non olet · About LEMON Manuals