Diagnosis Procedure

Check "Self-diagnosis result" using CONSULT. Refer to "DTC INDEX ".

Is the inspection result normal? 

YES: GO TO 2.

NO: Repair or replace the malfunctioning parts.

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Turn ignition switch ON.
4. Check voltage between IPDM E/R harness connector and ground.

   (+)		(-)	Condition		Voltage (V) (Approx.)
   IPDM E/R
   Connector	Terminal
   E5	30	Ground	Selector lever (A/T models)	N or P position	Battery voltage
   				Other than above	0
   			Clutch pedal (M/T models)	Depressed	Battery voltage
   				Not depressed	0

   Is the inspection result normal? 

   YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".

   NO: GO TO 3.

1. Disconnect BCM connector.
2. Check continuity between IPDM E/R harness connector and BCM harness connector.

   IPDM E/R		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   E5	30	M123	140 (A/T models)	Existed
   			114 (M/T models)

3. Check continuity between IPDM E/R harness connector and ground.

   IPDM E/R		Ground	Continuity
   Connector	Terminal
   E5	30		Not existed

   Is the inspection result normal? 

   YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

   NO: Repair or replace harness.