LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2014 >> Q60 Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> Steering >> Manual Steering >> Steering Control System (Convertible) >> DTC/Circuit Diagnosis >> Vehicle Speed Signal Circuit >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. PERFORM UNIFIED METER AND A/C AMP. SELF-DIAGNOSIS 

    With CONSULT 

    1. Turn the ignition switch ON.
    2. Perform "METER/M&A" self-diagnosis. Refer to "CONSULT FUNCTION (METER/M&A) ".

      Is any DTC detected? 

      YES: Check the DTC.

      NO: GO TO 2.

  2. CHECK HARNESS BETWEEN UNIFIED METER AND A/C AMP. AND POWER STEERING CONTROL UNIT 
    1. Turn the ignition switch OFF.
    2. Disconnect unified meter and A/C amp. harness connector.
    3. Disconnect power steering control unit harness connector.
    4. Check the continuity between unified meter and A/C amp. harness connector and power steering control unit harness connector.
      Unified meter and A/C amp. Power steering control unit Continuity
      Connector Terminal Connector Terminal
      M66 8 M108 8 Existed
    5. Check the continuity between power steering control unit harness connector and ground.
      Power steering control unit - Continuity
      Connector Terminal
      M108 8 Ground Not existed

      Is the inspection result normal? 

      YES: GO TO 3.

      NO: Repair or replace error-detected parts.

  3. CHECK VEHICLE SPEED SIGNAL (1) 
    1. Connect unified meter and A/C amp. harness connector.
    2. Check the unified meter and A/C amp. input/output standard values. Refer to "REFERENCE VALUE ".

      Is the inspection result normal? 

      YES: GO TO 4.

      NO: Replace unified meter and A/C amp. Refer to "EXPLODED VIEW ".

  4. CHECK VEHICLE SPEED SIGNAL (2) 
    1. Turn the ignition switch OFF.
    2. Connect power steering control unit harness connector.
    3. Check the signal between power steering control unit harness connector and ground with oscilloscope.
      Power steering control unit - Condition Voltage (Approx.)
      Connector Terminal
      M108 8 Ground Vehicle speed: 40 km/h (25 MPH)
      CAUTION: Check air pressure of tire under standard condition.
      NOTE: The maximum voltage varies depending on the specification (destination unit).
      G05223700

      Is the inspection result normal? 

      YES: GO TO 5.

      NO: Replace power steering control unit. Refer to "REMOVAL AND INSTALLATION ".

  5. CHECK TERMINALS AND HARNESS CONNECTORS 
    • Check the power steering control unit pin terminals for damage or loose connection with harness connector.
    • Check the unified meter and A/C amp. pin terminals for damage or loose connection with harness connector.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Repair or replace error-detected parts.

scientia non olet · About LEMON Manuals