Component Function Check

Perform "Self Diagnosis" of unified meter and A/C amp. with CONSULT.

Is any DTC detected? 

YES: Perform diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to "DTC INDEX ".

NO: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect fuel level sensor unit and fuel pump (main) and fuel level sensor unit (sub) connector.
3. Connect variable resistor between harness connector terminals located on the vehicle side of the fuel level sensor unit and fuel pump (main) and the fuel level sensor unit (sub).

   Fuel level sensor unit and fuel pump (main)		Fuel level sensor unit (sub)
   Connector	Terminal	Connector	Terminal
   B22	5	B21	1

4. Set variable resistor according to the resistance value shown in the following table and turn ignition switch ON.

   Resistance (Ω)(1) (Approx.)	Fuel gauge indication position (Approx.)
   Less than 6.0	Full
   25.5	3/4
   45.5	2/4
   66.0	1/4
   More than 80.0	Empty
   (1) Reference resistance values used when the combination meter judges the indication position of the fuel gauge.

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: GO TO  4.

Check the fuel level sensor unit and fuel pump (main) and the fuel level sensor unit (sub). Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace fuel level sensor unit and fuel pump (main) or fuel level sensor unit (sub). Refer to "REMOVAL AND INSTALLATION ".

Select "FUEL METER" that is the data monitor item of "METER/M&A". Apply resistance according to the table below and check the monitor value.

Is the inspection result normal? 

YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".

NO: Refer to "DIAGNOSIS PROCEDURE ".