ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (ECM): Special Repair Requirement

WARNING: This page is about a different variant/trim than selected.

CHECK ECM PART NUMBER
Check ECM part number to see whether it is blank ECM or not.
NOTE:
- Part number of blank ECM is 23703 - xxxxx.
- Check the part number when ordering ECM or with the one included in the label on the container box.
Is the ECM a blank ECM?

YES: GO TO 2.

NO: GO TO 4.
SAVE ECM PART NUMBER
Read out the part number from the old ECM and save the number, following the programming instructions.

Refer to "CONSULT Operation Manual".
NOTE:
- The ECM part number is saved in CONSULT.
- Even when ECM part number is not saved in CONSULT, go to 3.
: GO TO 3.
PERFORM ECM PROGRAMMING
After replacing ECM, perform the ECM programming. Refer to "CONSULT Operation Manual".
NOTE:
- During programming, maintain the following conditions:
  - Ignition switch: ON
  - Electric load: OFF
  - Brake pedal: Not depressed
  - Battery voltage: 12 - 13.5 V (Be sure to check the value of battery voltage by selecting "BATTERY VOLT" in "Data monitor" of CONSULT.)
: GO TO 5.
REPLACE ECM
Replace ECM.

: GO TO 5.
PERFORM INITIALIZATION OF IVIS (NATS) SYSTEM AND REGISTRATION OF ALL IVIS (NATS) IGNITION KEY IDS
Refer to "ECM RE-COMMUNICATING FUNCTION: SPECIAL REPAIR REQUIREMENT ".

: GO TO 6.
PERFORM VIN REGISTRATION
Refer to "VIN REGISTRATION: SPECIAL REPAIR REQUIREMENT ".

: GO TO 7.
PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING
Refer to "ACCELERATOR PEDAL RELEASED POSITION LEARNING: SPECIAL REPAIR REQUIREMENT ".

: GO TO 8.
PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
Refer to "THROTTLE VALVE CLOSED POSITION LEARNING: SPECIAL REPAIR REQUIREMENT ".

: GO TO 9.
PERFORM IDLE AIR VOLUME LEARNING
Refer to "IDLE AIR VOLUME LEARNING: SPECIAL REPAIR REQUIREMENT ".

: END