Work Procedure

With CONSULT

1. Perform INSPECTION MODE 5. Refer to "DESCRIPTION ".
2. Start engine and warm it up to normal operating temperature.
3. Select "SELF-LEARNING CONT" in "WORK SUPPORT" mode of "ENGINE" using CONSULT.
4. Clear mixture ratio self-learning value by touching "CLEAR".

With GST

1. Perform INSPECTION MODE 5. Refer to "DESCRIPTION ".
2. Start engine and warm it up to normal operating temperature.
3. Turn ignition switch OFF.
4. Disconnect mass air flow sensor harness connector.
5. Turn ignition switch ON.
6. Perform INSPECTION MODE 5. Refer to "DESCRIPTION ".
7. Restart engine and let it idle for at least 5 seconds.
8. Stop engine and reconnect mass air flow sensor harness connector.
9. Select Service $03 with GST. Make sure DTC P0102 is detected.
10. Select Service $04 with GST to erase the DTC P0102.

    : END