CONFIGURATION (AROUND VIEW MONITOR CONTROL UNIT): Special Repair Requirement
- SAVING VEHICLE SPECIFICATION
CONSULT Configuration
Perform "Before Replace ECU", and save the current vehicle specification in CONSULT.
Is the vehicle specification saved normally?
YES: GO TO 2.
NO: GO TO 4.
- REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".
: GO TO 3.
- WRITING VEHICLE SPECIFICATION
CONSULT Configuration
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to around view monitor control unit.
: GO TO 6.
- REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".
: GO TO 5.
- WRITE VEHICLE SPECIFICATION
CONSULT Configuration
Select "Manual Configuration", and write the vehicle specification to around view monitor control unit.
NOTE: Around view monitor control unit does not have any setting items. Selection of items on "Manual Configuration" screen is not required.: GO TO 6.
- PERFORM SELF-DIAGNOSIS
CONSULT Self Diagnostic Result
Perform self-diagnosis of CONSULT, and check whether or not DTC U1305 is detected.
Is DTC U1305 detected?
: GO TO 5.
: GO TO 7.
- OPERATION CHECK
Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.
: WORK END