Component Inspection (Throttle Position Sensor)

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "WORK PROCEDURE ".
4. Turn ignition switch ON.
5. Set selector lever position to D.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F110	91 (TP sensor 1 signal)	97 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	79 (TP sensor 2 signal)			Fully released	Less than 4.75
   				Fully depressed	More than 0.36

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: GO TO 2.

Replace electric throttle control actuator. Refer to "REMOVAL AND INSTALLATION ".

: INSPECTION END