April 5, 2026: LEMON Manuals is launched! Read the announcement.

Work Procedure

NOTE: In fail-safe mode, can not perform work support. (Except that DTC P181F or P182B is detected.)

PREPARATION BEFORE WORK
With CONSULT
1. Continue the following condition at vehicle.
  Engine: Running
  
  Parking brake: Apply
  
  Brake pedal: Release
  
  Electrical system like air conditioner: OFF
  
  CAUTION: Never drive the vehicle.
2. Check "4WD MODE", "T/M RANGE", "COMPR VHCL SPEED", "MOTOR POWER SUP" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
3. Continue the following condition.
  4WD MODE: 4L
  
  T/M RANGE: N
  
  COMPR VHCL SPEED: 0 km/h (Never drive the vehicle)
  
  MOTOR POWER SUP: More than 11 V
  
  : GO TO 2.
PERFORM LOCK POSITION SENOR LEARNING
With CONSULT
1. Select "LOCK SLEEVE SENSOR LEARNING" of CONSULT "WORK SUPPORT" for "ALL MODE AWD/4WD".
2. Select "Start".
3. Wait until the motor operation stop.
  Is "Error" detected?
  
  YES (within 5 times): GO TO 1.
  
  YES (over 5 times): Transfer assembly is mechanical malfunction. Replace transfer assembly. Refer to "REMOVAL AND INSTALLATION ".
  
  NO: GO TO 3.
PERFORM SELF-DIAGNOSIS
With CONSULT
1. Erase self-diagnosis result for "ALL MODE AWD/4WD".
2. Turn the ignition switch ON to OFF.
  CAUTION: Wait for 10 seconds after turning ignition switch OFF.
3. Start the engine.
  CAUTION: Never drive the vehicle.
4. Perform self-diagnosis for "ALL MODE AWD/4WD".
  Is "DTC P182B" detected?
  
  YES: GO TO 1.
  
  NO: WORK END