Work Procedure

Initialize the system if any of the following work has been done. Refer to Work Procedure .

• When control unit replaced.
• Electric power supply to power window switch or motor is interrupted by blown (open) fuse or disconnection and connection of the negative terminal of battery, etc.
• Removal and installation of regulator assembly.
• Power supply to the power window main switch or power window motor is cut off by the removal

  of battery terminal or if the battery fuse is blown (open).

• Disconnection and connection of power window main switch harness connector.
• Removal and installation of motor from regulator assembly.
• Operation of regulator assembly as an independent unit.
• Removal and installation of door glass.
• Removal and installation of door glass run.

The following specified operations can not be performed under the non-initialized condition.

• Auto-up operation
• Anti-pinch function

1. STEP 1 

   Fully open the door window.

   GO TO 2.

2. STEP 2 

   Place a piece of wood near fully closed position.

   GO TO 3.

3. STEP 3 

   Close door glass completely with AUTO-UP.

   GO TO 4.

4. STEP 4 

   Check the following conditions

   • Check that glass lowers for approximately [front: 150 mm (5.9 in), rear: 116 mm (4.5 in)] without pinching piece of wood and stops.
   • Check that glass does not rise not when operating the power window main switch while lowering.
   CAUTION:

   • Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
   • Check that AUTO-UP operates before inspection when system initialization is performed.
   • Do not check with hands and other body parts because they may be pinched. Do not get pinched.
   • It may switch to fail-safe mode if open/close operation is performed continuously without full close.

     Perform initial setting in that situation. Refer to Work Procedure .

   END