Work Procedure

WARNING: This page is about a different car, the 2020 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Perform the following operations when replacing BCM. [For details, Refer to Work Procedure .]

BEFORE REPLACEMENT

When replacing BCM, save or print current vehicle specification with CONSULT configuration before replacement.

NOTE: If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.

AFTER REPLACEMENT

CAUTION: When replacing BCM, always perform "Read / Write Configuration" or "Manual Configuration" with CONSULT. Or not doing so, BCM control function does not operate normally.

Complete the procedure of "Read / Write Configuration" in order.
Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
If you set incorrect "Read / Write Configuration" or "Manual Configuration", incidents might occur.

NOTE: When replacing BCM, perform the system initialization (NATS) (if equipped).

SAVING VEHICLE SPECIFICATION (BCM)
CONSULT Configuration

Perform "Before Replace ECU" of "Read/ Write Configuration" to save or print current vehicle specification. Refer to Work Procedure .

NOTE: If "Before Replace ECU" of "Read/Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.

GO TO 2.
REPLACE BCM
Replace BCM. Refer to BCM : Removal & Installation .

GO TO 3.
WRITING VEHICLE SPECIFICATION (BCM)
CONSULT Configuration

Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .

GO TO 4.
INITIALIZE BCM (NATS) (IF EQUIPPED)
Perform BCM initialization. (NATS)

WORK END