VR30DDTT engine

1. Check the voltage between Fuel pump control module terminals under the following conditions.

   FUEL PUMP CONTROL MODULE			Condition	Voltage
   Connector	+	-
   	Terminal	Terminal
   B11	1	2	For 1 second after turning ignition switch ON	Approx. 9.9 V
   			More than 1 second after turning ignition switch ON	Approx. 0 V
   			Idle speed	Approx. 9.9 V

Is the inspection result normal?

YES

INSPECTION END

NO

Replace Fuel pump control module. Refer to FUEL PUMP CONTROL MODULE (FPCM) : Removal & Installation .