Work Procedure

Initialize the system if any of the following work has been done. Refer to Work Procedure .

• When control unit replaced.
• Electric power supply to power window switch or motor is interrupted by blown (open) fuse or disconnection and connection of the negative terminal of battery, etc.
• Removal and installation of regulator assembly.
• Power supply to the power window main switch or power window motor is cut off by the removal

  of battery terminal or if the battery fuse is blown (open).

• Disconnection and connection of power window main switch harness connector.
• Removal and installation of motor from regulator assembly.
• Operation of regulator assembly as an independent unit.
• Removal and installation of door glass.
• Removal and installation of door glass run.

The following specified operations can not be performed under the non-initialized condition.

• Auto-up operation
• Anti-pinch function

1. SYSTEM INITIALIZATION 

   Perform system initialization. Refer to Work Procedure .

   GO TO 2.

2. CHECK ANTI-PINCH FUNCTION 

   Check anti-pinch function. Refer to Work Procedure .

   END