Models with Around View Monitor System
- CHECK FUSE
- Turn ignition switch OFF.
- Check that the following fuse is not blown (open).
Power source
Fuse No.
Capacity
Battery
#7
15 A
Ignitions switch ACC
#1
10 A
Ignition switch ON
#14
5 A
Is the fuse blown (open)?
YES
Replace fuse after repairing the applicable circuit.
NO
GO TO 2.
- CHECK POWER SUPPLY CIRCUITS
Check voltage between around view monitor control unit harness connector and ground.
Signal name
Terminals
Ignition switch position
Value (Approx.)
(+)
(-)
Around view monitor control unit
Connector
Terminal
Battery power supply
B50
2
Ground
OFF
Battery voltage
ACC power supply
4
ACC
Ignition signal
3
ON
Is inspection result normal?
YES
GO TO 3.
NO
Check harness between around view monitor control unit and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit connector.
- Check continuity between around view monitor control unit harness connector and ground.
Terminals
Continuity
(+)
(-)
Around view monitor control unit
Connector
Terminal
B50
1
Ground
Existed
Is inspection result normal?
YES
INSPECTION END
NO
Repair harness or connector.