With Blind Spot Warning System
- CHECK SELF-DIAGNOSIS RESULTS
Check if any DTC other than "C1B20" is detected in "Self Diagnostic Result" of "BSW/BUZZER".
Is any DTC detected?
YES
diagnosis on the detected DTC and repair or replace the malfunctioning parts. Refer to DTC Index .
NO
GO TO 2.
- CHECK DRIVER ASSISTANCE BUZZER SIGNAL CIRCUIT FOR OPEN
- Turn ignition switch OFF.
- Disconnect the driver assistance buzzer connector.
- Disconnect the driver assistance buzzer control module connector.
- Check continuity between the driver assistance buzzer control module harness connector and driver assistance buzzer harness connector.
Driver assistance buzzer control module
Driver assistance buzzer
Continuity
Connector
Terminal
Connector
Terminal
M56
8
M107
1
Existed
16
2
Is the inspection result normal?
YES
GO TO 3.
NO
Repair the harnesses or connectors.
- CHECK DRIVER ASSISTANCE BUZZER SIGNAL CIRCUIT FOR SHORT
Check continuity between the driver assistance buzzer control module harness connector and ground.
Driver assistance buzzer control module
Ground
Continuity
Connector
Terminal
M56
8
Not existed
16
Is the inspection result normal?
YES
GO TO 4.
NO
Repair the harnesses or connectors.
- CHECK DRIVER ASSISTANCE BUZZER
Check driver assistance buzzer. Refer to Component Inspection .
Is the inspection result normal?
YES
Replace the driver assistance buzzer control module. Refer to DRIVER ASSISTANCE BUZZER CONTROL MODULE : Removal & Installation .
NO
Replace the driver assistance buzzer. Refer to DRIVER ASSISTANCE BUZZER : Removal & Installation .