Models with Around View Monitor System

1. Turn ignition switch OFF.
2. Disconnect around view monitor control unit connector and door mirror (driver side) connector.
3. Check continuity between around view monitor control unit harness connector and door mirror (driver side) harness connector.
   With automatic drive positioner
   
   

   Around view monitor control unit		Door mirror (driver side)		Continuity
   Connector	Terminal	Connector	Terminal
   B51	56	D56	6	Existed
   	58		18

   Without automatic drive positioner
   
   

   Around view monitor control unit		Door mirror (driver side)		Continuity
   Connector	Terminal	Connector	Terminal
   B51	56	D3	6	Existed
   	58		18

4. Check continuity between around view monitor control unit harness connector and ground.
   With automatic drive positioner
   
   

   Door mirror (driver side)		Ground	Continuity
   Connector	Terminal
   D56	6		Not existed
   	18

   Without automatic drive positioner
   
   

   Door mirror (driver side)		Ground	Continuity
   Connector	Terminal
   D3	6		Not existed
   	18

Is the inspection result normal?

YES

GO TO 2.

NO

Repair harness or connector.

1. Connect around view monitor control unit connector and door mirror (driver side) connector.
2. Turn ignition switch ON.
3. Check voltage between around view monitor control unit harness connector and ground.

   Around view monitor control unit			Condition	Voltage (Approx.)
   Connector	Terminals
   	(+)	(-)
   	Terminal
   B51	56	58	"CAMERA" switch is ON or shift position is "R".	6.0 V

Is the inspection result normal?

YES

GO TO 3.

NO

Replace around view monitor control unit. Refer to AROUND VIEW MONITOR CONTROL UNIT : Removal & Installation .

1. Turn ignition switch OFF.
2. Disconnect around view monitor control unit connector and door mirror (driver side) connector.
3. Check continuity between around view monitor control unit harness connector and door mirror (driver side) harness connector.
   With automatic drive positioner
   
   

   Around view monitor control unit		Door mirror (driver side)		Continuity
   Connector	Terminals	Connector	Terminals
   B51	59	D56	5	Existed
   	60		17

   Without automatic drive positioner
   
   

   Around view monitor control unit		Door mirror (driver side)		Continuity
   Connector	Terminals	Connector	Terminals
   B51	59	D3	5	Existed
   	60		17

4. Check continuity between around view monitor control unit harness connector and ground.

   Around view monitor control unit		Ground	Continuity
   Connector	Terminals
   B51	59		Not existed
   	60

Is the inspection result normal?

YES

GO TO 4.

NO

Repair harness or connector.

1. Connect around view monitor control unit connector and door mirror (driver side) connector.
2. Turn ignition switch ON.
3. Check signal between around view monitor control unit harness connector.

   Around view monitor control unit			Condition	Reference value
   Connector	Terminals
   	(+)	(-)
   	Terminal
   B51	59	60	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

Replace around view monitor control unit. Refer to AROUND VIEW MONITOR CONTROL UNIT : Removal & Installation .

NO

Replace side camera LH. Refer to SIDE CAMERA : Removal & Installation .