Data Monitor
|
Item [Unit] |
Description |
|
|
IGN VOLT |
[V] |
Displays the ignition power supply voltage. |
|
CONTROL MODULE MALF |
[Off / On] |
Displays the chassis control module malfunction. |
|
CAN DIAG STATUS |
[Off / On] |
Displays the CAN network diagnosis status. |
|
STP LAMP OFF RELAY 1 |
[Off / On] |
Displayed but not used. |
|
STP LAMP OFF RELAY 2 |
[Off / On] |
Displayed but not used. |
|
ESS RELAY |
[Off / On] |
Displayed but not used. |
|
VEHICLE SPEED |
[km/m] |
Displays the vehicle speed. |
|
FR WHEEL SPEED |
[RPM] |
Displays the rotational speed of front RH tire. |
|
FL WHEEL SPEED |
[RPM] |
Displays the rotational speed of front LH tire. |
|
RR WHEEL SPEED |
[RPM] |
Displays the rotational speed of rear RH tire. |
|
RL WHEEL SPEED |
[RPM] |
Displays the rotational speed of rear LH tire. |
|
STEERING ANG SENSOR |
[deg] |
Displays the steering angle from the steering angle sensor. |
|
DECEL G SENSOR |
[G] |
Displays the decel G. |
|
SIDE G SENSOR |
[G] |
Displays the side G. |
|
YAW RATE SENSOR |
[deg/s] |
Displays the yaw rate. |
|
ACCELE PEDAL POSITION |
[%] |
Displays the accelerator pedal position. |
|
THROTTLE CONTROL |
[NORMAL / INCORR / PREV / INPOSSI] |
Displays the electric throttle status. |
|
SHIFT POSITION |
[Off / P / R / N / D (A) / S / L / B / 1- 6 / M 1 -M 8 / A 1 - A 6] |
Displays the shift position. |
|
BRAKE SWITCH 2 |
[Off / On] |
Displays the brake pedal operating status. |
|
BRAKE SWITCH 1 |
[Off / On] |
Displays the brake pedal operating status. |
|
STOP LAMP SW |
[ACT / INACT] |
Displays the stop lamp switch status. |
|
PRESS SENSOR |
[bar] |
Displays the brake fluid pressure. |
|
ABS |
[NORMAL / ABNOR] |
Displays the ABS function status. |
|
ABS MALF |
[Off / On] |
Displays the ABS function malfunction status. |
|
EBD |
[NORMAL / ABNOR] |
Displays the EBD function status. |
|
TCS |
[NORMAL / ABNOR] |
Displays the TCS function status. |
|
TCS MALF |
[Off / On] |
Displays the TCS function malfunction status. |
|
VDC |
[NORMAL / ABNOR] |
Displays the VDC function status. |
|
VDC MALF |
[Off / On] |
Displays the VDC function malfunction status. |
|
VDC OFF SWITCH |
[Off / On] |
Displays the VDC OFF switch status. |
|
PARKING BRAKE |
[Off / On] |
Displays the parking brake operating status. |
|
ACCELE PEDAL MALF |
[Off / On] |
Displays the accelerator pedal malfunction status. |
|
DRV TRQ CTRL MODE |
[INITIAL / NORMAL / STOP 1 / STOP 2 / LIMIT 1 / PROHIBI] |
Displays the status of correction to slightly increase/decrease the drive torque. |
|
DRV TRQ CTRL PERMIS 1 |
[NO PER / PERMIS] |
Displayed but not used. |
|
DRV TRQ CTRL PERMIS 2 |
[NO PER / PERMIS] |
Displayed but not used. |
|
DRV TRQ CTRL STOP |
[REQ / NO REQ] |
Displayed but not used. |
|
DRV TRQ CTRL PROHIBIT |
[REQ / NO REQ] |
Displayed but not used. |
|
DRIVE MODE SELECTOR |
[STD / SPORT / SNOW / ECO / SPORT+ / PERSO / NOT / NOT SET] |
Displays the drive mode select switch selection status. |
|
LOG-IN PERMIS |
[NO PER / PERMIS] |
Displays the login authority status of Infiniti InTuition function. |
|
I-KEY LINK |
[Off / On] |
Displays the Intelligent Key linking status of Infiniti InTuition function. |
|
USER |
[USER A / USER B / USER C / GUEST] |
Displays the current user status of Infiniti InTuition function. |
|
ENGINE/TM SETTING |
[SPOT / STD / ECO / SNOW] |
Displays the engine/transmission setting status with Infiniti drive mode selector function. |
|
STRG SETTING |
[STD / SPT / TOUR / SPT-L] |
Displays the steering setting characteristic. |
|
ALC SETTING |
[Off / LOW / HIGH] |
Displays the Active Lane Control setting status characteristic. |
|
ATC SETTING |
[Off / On] |
Displays the active trace control function setting characteristic. |
|
COMBI METER |
[STD / SPORT / SNOW / ECO / PERSO] |
Displays the combination meter function setting characteristic. |
|
ATC 1 |
[Off / On] |
Displays the active trace control function operating status. |
|
ATC 2 |
[Off / On] |
Displays the active trace control function operating status. |
|
ATC 4 |
[Off / On] |
Displays the active trace control function operating status. |
|
ATC 3 |
[Off / On] |
Displays the active trace control function operating status. |
|
FL TIRE DISP |
[DEF / 1] |
Displays the status of front LH tire displayed on the information display in the combination meter. |
|
FR TIRE DISP |
[DEF / 1] |
Displays the status of front RH tire displayed on the information display in the combination meter. |
|
RL TIRE DISP |
[DEF / 1] |
Displays the status of rear LH tire displayed on the information display in the combination meter. |
|
RR TIRE DISP |
[DEF / 1] |
Displays the status of rear RH tire displayed on the information display in the combination meter. |
|
TURN DISP |
[N STEER / LEFT / RIGHT] |
Displays the turning direction of active trace control function on the information display in the combination meter. |
|
ALC LEVEL |
[0 - 4] |
Displays the active/inactive status of Active Lane Control. |
|
ALC STATUS |
[INACT / ACT] |
Displays the Active Lane Control operating status. |
|
ATC DISP |
[Off / On] |
Displays the operating status of active trace control function on the information display in the combination meter. |
|
ALC DISP |
[Off / On] |
Displays the operating status of Active Lane Control on the information display in the combination meter. |
|
AEB COMMAND 1 |
[--] |
Displayed but not used. |
|
AEB COMMAND 2 |
[--] |
Displayed but not used. |
|
AEB SLIP RATE |
[%] |
Displayed but not used. |
|
ALC SYSTEM |
[Off / On] |
Displays the Active Lane Control activation status. |
|
LANE MARKER (LH) |
[NOT / DETECT] |
Displays the lane marker (LH) detection status. |
|
LANE MARKER (RH) |
[NOT / DETECT] |
Displays the lane marker (RH) detection status. |
|
TURN SIGNAL (LH) |
[Off / On] |
Displays the turn signal switch (LH) operating status. |
|
TURN SIGNAL (RH) |
[Off / On] |
Displays the turn signal switch (RH) operating status. |
|
TURN SIGNAL SWITCH |
[Off / LEFT / RIGHT / MALF] |
Displays the turn signal switch operating status. |
|
DAST |
[Off / On] |
Displays the Direct Adaptive Steering operating status. |
|
ROAD DISTORTION |
[1/m] |
Displays the road curvature. |
|
COMMAND ST ANG |
[rad] |
Displays the steering command value to Direct Adaptive Steering. |
|
ST PINION ANG |
[rad] |
Displays the steering pinion angle. |
|
ST WHL FORCE TORQUE |
[Nm] |
Displays the steering wheel force torque. |
|
COMMAND ST WHL FORCE |
[N] |
Displays the reaction force command value to Direct Adaptive Steering. |
|
LDW DISP |
[On / MALF] |
Displays the LDW status received from ADAS control unit. |
|
LDP DISP |
[On / MALF] |
Displays the LDP status received from ADAS control unit. |
|
BSI DISP |
[On / MALF] |
Displays the Blind spot intervention function status received from ADAS control unit. |
|
ST SWITCH COND |
[OK / NG 1 / NG 2] |
Displays the steering switch status received from ADAS control unit. |
|
BSW COND |
[NORMAL / ABNOR] |
Displays the BSW status received from ADAS control unit. |
|
ADAS COND |
[NORMAL / ABNOR] |
Displays the ADAS status received from ADAS control unit. |
|
COLLISION WARN |
[Off / On] |
Displays the collision warning status received from ADAS control unit. |
|
ICC ACTIVE |
[Off / On] |
Displays the ICC operating status received from ADAS control unit. |
|
IBA ACTIVE |
[Off / On] |
Displays the FEB operating status received from ADAS control unit. |
|
DR BUZZER STATUS |
[NO / 1 / 2 / 3 / 1, 2 / 2, 3 / 1, 3 / 4] |
Displayed but not used. |
|
LDW COND |
[On / MALF] |
Displays the LDW status transmitted to ADAS control unit. |
|
LDP COND |
[On / MALF] |
Displays the LDP status transmitted to ADAS control unit. |
|
BSI COND |
[On / MALF] |
Displays the blind spot intervention function status transmitted to ADAS control unit. |
|
LDP BRAKE CANCEL |
[NONE / SLIP / SNOW / VDC OF] |
Displays the LDP cancel cause transmitted to ADAS control unit. |
|
BSI BRAKE CANCEL |
[NONE / SLIP / SNOW / VDC OF] |
Displays the blind spot intervention function cancel cause transmitted to ADAS control unit. |
|
CAMERA COND |
[NORMAL / ABNOR] |
Displays the lane camera unit status. |
|
CAMERA TEMP COND |
[NORMAL / ABNOR] |
Displays the lane camera unit status by temperature. |
|
CAMERA COMM COND |
[NORMAL / ABNOR] |
Displays the communication status with the lane camera unit status. |
|
CAMERA HIGH TEMP (LDW) |
[NORMAL / ABNOR] |
Displays the lane camera unit system cancel request due to high temperature (LDW). |
|
CAMERA HIGH TEMP (LDP) |
[NORMAL / ABNOR] |
Displays the lane camera unit system cancel request due to high temperature (LDP) |
|
CAMERA HIGH TEMP (BSI) |
[NORMAL / ABNOR] |
Displays the lane camera unit system cancel request due to high temperature (Blind spot intervention) |
|
SIDE RADAR BLOCK CANCEL |
[NORMAL / BLOCK] |
Displays the side radar status. |
|
BSI LAMP REQ (LH) |
[Off / On] |
Displays the blind spot intervention indicator blink request at blind spot intervention operation (LH). |
|
BSI LAMP REQ (RH) |
[Off / On] |
Displays the blind spot intervention indicator blink request at blind spot intervention operation (RH). |
|
LANE DEPARTURE DISP (LH) |
[NO DISP / DEVIAT] |
Displays the deviating status on the LH side lane. |
|
LANE DEPARTURE DISP (RH) |
[NO DISP / DEVIAT] |
Displays the deviating status on the RH side lane. |
|
LDP/BSI ACTIVE |
[Off / On] |
Displays the LDP/blind spot intervention function operation status. |
|
ADAS COND |
[NORMAL / ABNOR] |
Displayed but not used. |
|
DR BUZZER COND |
[NORMAL / ABNOR] |
Displayed but not used. |
|
OUTSIDE TEMP |
[ deg. C] |
Displays the ambient temperature. |
|
WIPER STATUS |
[Off / LOW / HIGH / MALF] |
Displays the front wiper operating status. |
|
Engine RPM |
[RPM] |
Displays the engine speed. |
|
FR shock ab drive current |
[A] |
Displays the electronically controlled shock absorber (FR) drive current. |
|
FL shock ab drive current |
[A] |
Displays the electronically controlled shock absorber (FL) drive current. |
|
RR shock ab drive current |
[A] |
Displays the electronically controlled shock absorber (RR) drive current. |
|
RL shock ab drive current |
[A] |
Displays the electronically controlled shock absorber (RL) drive current. |
|
Shock absorber control 1 |
[Off / On] |
Displays the electronically controlled shock absorber control condition. |
|
Shock absorber control 2 |
[Off / On] |
Displays the electronically controlled shock absorber control condition. |
|
Shock absorber control 3 |
[Off / On] |
Displays the electronically controlled shock absorber control condition. |
|
FR shock ab command current |
[A] |
Displays the electronically controlled shock absorber (FR) command current. |
|
FL shock ab command current |
[A] |
Displays the electronically controlled shock absorber (FL) command current. |
|
RR shock ab command current |
[A] |
Displays the electronically controlled shock absorber (RR) command current. |
|
RL shock ab command current |
[A] |
Displays the electronically controlled shock absorber (RL) command current. |