Models with Around View Monitor System

1. Turn ignition switch OFF.
2. Disconnect around view monitor control unit harness connector and front camera harness connector.
3. Check the continuity between around view monitor control unit harness connector and front camera harness connector.

   Around view monitor control unit		Front camera		Continuity
   Connector	Terminal	Connector	Terminal
   B51	67	E116	6	Existed

4. Check continuity between around view monitor control unit harness connector and ground.

   Around view monitor control unit		Ground	Continuity
   Connector	Terminal
   B51	67		Not existed

Is the inspection result normal?

YES

GO TO 2.

NO

Repair harness or connector.

1. Erase DTC.
2. Turn ignition switch OFF.
3. Replace front camera. Refer to FRONT CAMERA : Removal & Installation .
4. Turn ignition switch ON.
5. Select "Self Diagnostic Result" mode of "AVM" using CONSULT.
6. Check DTC.

Is DTC C1A57 detected?

YES

Replace around view monitor control unit. Refer to AROUND VIEW MONITOR CONTROL UNIT : Removal & Installation .

NO

INSPECTION END