Models with Around View Monitor System
- CHECK CONTINUITY REAR CAMERA POWER SUPPLY AND GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit connector and rear camera connector.
- Check continuity between around view monitor control unit harness connector and rear camera harness connector.
Around view monitor control unit
Rear camera
Continuity
Connector
Terminal
Connector
Terminal
B51
50
T50
8
Existed
52
7
- Check continuity between around view monitor control unit harness connector and ground.
Around view monitor control unit
Ground
Continuity
Connector
Terminal
B51
50
Not existed
Is the inspection result normal?
YES
GO TO 2.
NO
Repair harness or connector.
- CHECK VOLTAGE REAR CAMERA POWER SUPPLY
- Connect around view monitor control unit connector and rear camera connector.
- Turn ignition switch ON.
- Check voltage between around view monitor control unit harness connector and ground.
Terminals
Condition
Voltage
(Approx.)
(+)
(-)
Around view monitor control unit
Connector
Terminal
B51
50
Ground
"CAMERA" switch is ON or shift position is "R".
6.0 V
Is the inspection result normal?
YES
GO TO 3.
NO
Replace around view monitor control unit. Refer to AROUND VIEW MONITOR CONTROL UNIT : Removal & Installation .
- CHECK CONTINUITY REAR CAMERA IMAGE SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect around view monitor control unit connector and rear camera connector.
- Check continuity between around view monitor control unit harness connector and rear camera harness connector.
Around view monitor control unit
Rear camera
Continuity
Connector
Terminal
Connector
Terminal
B51
53
T51
5
Existed
54
1
- Check continuity between around view monitor control unit harness connector and ground.
Around view monitor control unit
Ground
Continuity
Connector
Terminal
B51
53
Not existed
54
Is the inspection result normal?
YES
GO TO 4.
NO
Repair harness or connector.
- CHECK REAR CAMERA IMAGE SIGNAL
- Connect around view monitor control unit connector and rear camera connector.
- Turn ignition switch ON.
- Check signal between around view monitor control unit harness connector.
Around view monitor control unit
Condition
Reference value
Connector
Terminals
(+)
(-)
Terminal
B51
53
54
"CAMERA" switch is ON or shift position is "R".
Is the inspection result normal?
YES
Replace around view monitor control unit. Refer to AROUND VIEW MONITOR CONTROL UNIT : Removal & Installation .
NO
Replace rear camera. Refer to REAR CAMERA : Removal & Installation .