Component Function Check

1. Turn ignition switch ON.
2. Measure voltage between the following terminals of the combination meter.

   Combination meter			Condition	Voltage (Approx.)
   Connector	Terminals
   	(+)	(-)
   M57	36	17	When illumination control switch (+) is pressed	0 V
   			Other than the above	5.0 V
   	37		When illumination control switch (-) is pressed	0 V
   			Other than the above	5.0 V
   	18		When trip reset switch is pressed	0 V
   			Other than the above	5.0 V

Is the inspection result normal?

YES

INSPECTION END

NO

Refer to Diagnosis Procedure .