VR30DDTT engine
- CHECK STOP LAMP SWITCH-I
- Turn ignition switch OFF.
- Disconnect stop lamp switch harness connector.
- Check the continuity between stop lamp switch terminals under the following conditions.
Terminals
Condition
Continuity
3 and 4
Brake pedal
Fully released
Not existed
Slightly depressed
Existed
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- CHECK STOP LAMP SWITCH-II
- Adjust stop lamp switch installation. Refer to BRAKE PEDAL : Periodic Maintenance Operation .
- Check the continuity between stop lamp switch terminals under the following conditions.
Terminals
Condition
Continuity
3 and 4
Brake pedal
Fully released
Not existed
Slightly depressed
Existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace stop lamp switch. Refer to BRAKE PEDAL : Exploded View .