VR30DDTT engine

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Refer to Work Procedure .
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F142	103 [TP sensor 1 (bank 1)]	100	Accelerator pedal	Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	109 [TP sensor 1 (bank 2)]	121		Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	114 [TP sensor 2 (bank 1)]	100		Fully released	Less than 4.75
   				Fully depressed	More than 0.36
   	111 [TP sensor 2 (bank 2)]	121		Fully released	Less than 4.75
   				Fully depressed	More than 0.36

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Replace malfunctioning electric throttle control actuator.
2. Refer to Work Procedure .

INSPECTION END