Heater & Air Conditioning Control System (Diagnostics)

With CONSULT

1. Turn ignition switch ON.
2. Select the "HVAC" of "Re/programming, Configuration" with CONSULT.
3. Select the "Before Replace ECU" of "Read / Write Configuration", and save or print the current vehicle specification. Refer to Work Procedure .
   NOTE: If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing A/C auto amp. to write vehicle specification.

GO TO 2.

1. Turn ignition switch OFF.
2. Replace A/C auto amp. Refer to A/C AUTO AMP. : Removal & Installation .

GO TO 3.

With CONSULT

1. Turn ignition switch ON.
2. Select the "HVAC" of "Re/programming, Configuration" with CONSULT.
3. Select the "Manual Configuration" or "After Replace ECU" of "Read / Write Configuration", and write the vehicle specification into the A/C auto amp. Refer to Work Procedure .

GO TO 4.

Confirm that each function controlled by A/C auto amp. operates normally.

WORK END